💡
FFCP Klipper DWC Touchscreen
  • Introduction
  • Raspberry Pi Configuration
  • Setting up kiosk mode
  • Install Klipper
  • Install DWC2
  • Finishing Touches
  • Notes
  • Credit
Powered by GitBook
On this page

Was this helpful?

Introduction

NextRaspberry Pi Configuration

Last updated 5 years ago

Was this helpful?

This is a step by step guide to getting klipper running on a Flash Forge Creator Pro along with a DuetWifiController Touchscreen and Remote Frontend.

This is still a work in progress. please report any errors or needed updates. I tested this with a raspberry pi3 and had 2 successful prints. I also had 2 freeze on me after that. It seems chrome sucks up a lot of juice so i upgrade to a pi 4 with 4gb. We'll se how it pans out. I plan on making an actual touch interface that's not web driven and keep dwc2 for remote work so we don't have to run chrome on the pi allowing for older models to be used.